Garden Voila
Soil and Mulch

How Much Mulch Do I Need? Calculate Coverage by Area

A loader moving a pile of bulk mulch

To work out how much mulch you need, multiply the area of the bed by the depth you want, then add about 10 percent for settling. In US units, cubic yards needed = (square feet × depth in inches) ÷ 324. In metric, cubic metres = area in square metres × depth in metres. For most beds the depth is 2 to 3 inches (5 to 7.5 cm), a little more under trees, and never against the trunk. The sections below show the formulas, worked examples, a coverage chart, depth by mulch type and the mistakes that hurt plants. You can also skip the sums with our mulch calculator.

Getting the quantity right matters on both sides. Order too little and you pay a second delivery fee or end up with patchy cover. Order too much and you waste money or, worse, spread it too thick, which can starve roots of water and air. This guide covers the arithmetic first and then the horticulture that decides how deep your layer should be, drawing on University of Florida, University of New Hampshire and Mississippi State extension advice.

Quick answer: how much mulch do I need?

Bed size Depth Mulch needed
100 sq ft (9.3 m²) 2 in (5 cm) about 0.6 cubic yard (0.45 m³)
100 sq ft (9.3 m²) 3 in (7.5 cm) about 0.9 cubic yard (0.7 m³)
200 sq ft (18.6 m²) 3 in (7.5 cm) about 1.9 cubic yards (1.4 m³)
500 sq ft (46.5 m²) 3 in (7.5 cm) about 4.6 cubic yards (3.5 m³)
10 m² (108 sq ft) 75 mm (3 in) 0.75 m³ (about 1 cubic yard)

These figures are before the 10 percent allowance for settling and uneven ground. The University of Florida’s Gardening Solutions mulch guide gives the benchmark: one cubic yard covers 324 square feet at 1 inch deep, or about 108 square feet (roughly 10 by 10 feet) at 3 inches deep.

The mulch formula, step by step

US units (feet and inches)

  1. Measure the area in square feet (see the shape formulas below).
  2. Multiply by the depth in inches.
  3. Divide by 324 to get cubic yards.
  4. Add 10 percent.

UF’s worked example is a 128.5 square foot bed at 3 inches: 128.5 × 3 ÷ 324 = about 1.2 cubic yards. Add 10 percent and you would order 1.3 cubic yards.

Metric units (metres and millimetres)

  1. Measure the area in square metres.
  2. Convert the depth to metres (75 mm = 0.075 m).
  3. Multiply area by depth to get cubic metres.
  4. Add 10 percent.

Example: a 10 square metre bed at 75 mm gives 10 × 0.075 = 0.75 cubic metres; with the allowance, order about 0.83 cubic metres.

How to measure different bed shapes

  • Rectangles and squares: length × width.
  • Circles (such as a ring around a tree): radius × radius × 3.14, where the radius is half the width. UF suggests mulching an area at least 8 feet (2.4 m) across around a tree, ideally out to the drip line, which would be about 50 square feet and, at 3 inches, around 0.46 cubic yard.
  • Triangles: half the base × height.
  • Irregular or kidney-shaped beds: split into rectangles, circles and triangles, work out each area and add them together. UF recommends this method too.
  • Beds with plants in them: measure the whole bed; do not subtract the plants, because the small difference is covered by your 10 percent buffer.

Not sure of the area? Use string and pegs, a tape measure or a wheel measure, and sketch the bed on paper with the dimensions. A soil calculator uses the same geometry if you also need to fill raised beds.

Mulch coverage chart: how far does one load go?

Depth 1 cubic yard covers 1 cubic metre covers
1 in (25 mm) 324 sq ft 40 m²
2 in (50 mm) 162 sq ft 20 m²
3 in (75 mm) 108 sq ft 13.3 m²
4 in (100 mm) 81 sq ft 10 m²

Bagged mulch is sold by volume. A 2 cubic foot bag holds about 57 litres, so a cubic yard (27 cubic feet) is roughly 13 to 14 such bags, and a cubic metre is about 25 bags of 40 litres. Bulk delivery is usually cheaper once you need more than a cubic yard or two; use our garden cost calculator to compare, and check the overall garden costs before you order.

How deep should mulch be?

Extension services give slightly different numbers, which shows depth is a judgement call that depends on the plants and the material.

  • University of Florida: about 3 inches in general; 2 to 3 inches around established trees, shrubs and bedding plants; about 1 inch around seedlings, small vegetables and herbs. UF says not to exceed 3 inches because excessive mulch can divert rain and irrigation away from the root system.
  • University of New Hampshire: 2 to 4 inches under trees. UNH also promotes a “3-3-3 rule” for established trees: a 3 inch layer in a 3 foot ring, with at least 3 inches of clearance from the stem.
  • Mississippi State University: 2 to 3 inches for most uses, noting that many recommendations say 3 to 4 inches while some suggest up to 10, which the author calls way too much. It also warns that layers creep deeper over time because gardeners add fresh mulch faster than it breaks down.

A sensible target is 2 to 3 inches (5 to 7.5 cm) for beds and trees, about 1 inch (2.5 cm) around seedlings and herbs, and a thinner top-up each year rather than starting again.

Recommended depth and durability by mulch type

Mulch type Typical depth How long it lasts
Pine bark 2 to 3 in (5 to 7.5 cm) Settles slowly; a UF/IFAS study found it kept about two-thirds of its depth after two years
Pine straw 2 to 3 in (5 to 7.5 cm) Resists washing away but breaks down and settles quickly, so it needs frequent top-ups
Mixed hardwood chips 2 to 3 in (5 to 7.5 cm) Settles faster than pine bark, slower than straw or leaves
Leaves and grass clippings 1 to 2 in (2.5 to 5 cm) Free and nutrient-rich, but decompose fast; shred large leaves so they do not mat
Utility or arborist mulch 2 to 3 in (5 to 7.5 cm) Often free, but may contain weed seed, dirt and leaf matter; better for paths than beds
Rock, gravel, shell Per product Durable, but UF/IFAS does not recommend it in garden beds; best on paths and under downspouts
Rubber Per product Poor weed suppression, absorbs heat and can wash into waterways

UF also advises against cypress mulch in its Florida-Friendly programme because of concerns over where it is sourced. Which material suits which plant is covered in more detail in our soil and mulch section.

Mistakes that make mulch hurt plants

Mulch volcanoes

Piling mulch up against a trunk is the classic error. UNH explains that it buries the root flare, and in young trees can stop a flare forming, which makes trees less stable and more likely to blow over. Constant moisture against the bark encourages disease and decay, and deep piles can keep roots from spreading deeply, leaving trees vulnerable in summer drought. UF adds that it attracts rodents that chew young bark. Pull mulch back from the base: about 1 foot (30 cm) for large plants per UF, and at least 3 inches per the UNH rule for trees, and a couple of inches for small plants. Mississippi State suggests pulling mulch back and shaping it like a bowl to channel water to the roots.

Too deep or too early

Mississippi State warns that excessively deep mulch can delay spring warming and spring growth, and can slow fall soil cooling, which may keep plants from hardening off before winter. It recommends early spring as the time to mulch landscape beds.

Matting

Some materials mat down and block water and air; rake them lightly to loosen. Leaves are the usual culprit.

Mulching on hardscape edges

UF cautions against mulching along curbs, sidewalks or water edges, where nutrients and light material can wash into storm drains and waterways.

Contaminated wood

UF notes that mixed hardwood mulch can be contaminated with CCA from pressure-treated lumber, so do not use it around edible gardens, wear gloves when spreading it and look for the Mulch and Soil Council (MSC) logo. If you are unsure what a plant problem is, try our plant problem identifier.

Preparing the bed before you spread

  1. Clear perennial weeds and grass by the roots. A thick layer smothers small annual weeds, but perennials grow through gaps.
  2. Edge the bed so mulch stays put.
  3. Water first. Never mulch dry, cracked soil. If you are working out how much to irrigate, our garden watering calculator helps, and watering advice covers schedules.
  4. Spread evenly using a rake and check the depth with a ruler in several spots.
  5. Keep it off stems and trunks.

Benefits you are paying for

UF lists the main payoffs: conserving water and keeping soil moist longer after irrigation, moderating soil temperature extremes, suppressing weeds, controlling erosion, and, for organic types, adding nutrients and improving aeration, structure, drainage and nutrient retention as they decompose. Mississippi State adds that keeping foot traffic off mulched areas reduces soil compaction, and that a proper layer reduces weed germination by blocking sunlight. Mulch can also give you an alternative to bare ground in deep shade or hard-to-mow areas.

When and how often to replenish

UF says to add a thin new layer when organic mulch settles below 2 inches (5 cm), rather than replacing it entirely, which can damage surface roots. Lightly rake matted mulch to open it. Check beds twice a year; pine straw and leaves will need topping up sooner than bark. The best moment is early spring, as Mississippi State advises, before the soil warms and weeds germinate. When your plants are in planting season, mulch after planting so you do not bury seedlings.

Worked examples

A vegetable bed

A 4 by 8 foot raised bed is 32 square feet. At 1 inch (UF’s suggested depth for small vegetables and herbs): 32 × 1 ÷ 324 = 0.1 cubic yard, or about 2.7 cubic feet. That is roughly one and a half 2 cubic foot bags. If you also want to feed the bed, see the plants pages for crop-specific advice.

A shrub border

A border 30 feet long and 4 feet wide is 120 square feet. At 3 inches: 120 × 3 ÷ 324 = 1.1 cubic yards, so order 1.2 with the buffer.

A tree ring

A circle 8 feet across has a radius of 4 feet, so the area is 4 × 4 × 3.14 = 50 square feet. At 3 inches: 50 × 3 ÷ 324 = 0.46 cubic yard. Leave a mulch-free ring at the trunk, which reduces the volume slightly.

Free printable: the Year-Round Garden & Preserving Planner

Planting dates for 24 crops, monthly tasks, blanching times, canning safety numbers and a winter storage chart in one 8-page PDF. Enter your email to download it instantly and get our seasonal garden newsletter.

No spam. Unsubscribe any time. We never sell your email.

Frequently asked questions

How many bags of mulch do I need?

Divide the cubic feet you need by the bag size. At 3 inches deep, 100 square feet needs 25 cubic feet, which is 13 bags of 2 cubic feet each.

How deep should mulch be around trees?

UF says 2 to 3 inches, UNH says 2 to 4 inches. Either way, keep it off the trunk and avoid a volcano shape.

Can I add new mulch over old mulch?

Yes. UF recommends a thin top-up when the layer drops below 2 inches, instead of replacing everything, which can damage surface roots.

Is it a problem if mulch smells sour?

A sour or ammonia smell usually means wet, compacted material decomposing without air. Rake it out, let it dry and thin the layer.

Is more mulch better?

No. UF warns that over 3 inches can shed water away from roots, and Mississippi State calls up to 10 inches way too much.

Reviewed October 2026. Sources: University of Florida IFAS, Choosing and Installing Mulches; University of New Hampshire Extension, Volcanoes Kill Trees!; Mississippi State University Extension, Use mulch for beauty and weed, temperature control. Explore more tools at Gardenvoila tools.